|
| |
Stepper Motor Driver
|
|
|
|
Related Products
|
Features
- Low Cost
- 12 - 40 VDC Input Power
- High Output Current, 4 Amps Peak
- No Minimum Inductance
- Resistor Programmable Current
Adjustment
- Opto-isolated Inputs, Step, Direction, Enable, Reset
- Step Frequency up to 5 MHz
- 25 KHz Chopper Drive
- Status Indicator - Axis ON
- Operating Temperature, 0 - 70 C at
Heatsink
|
Features Cnt'd
- Crystal Controlled Clock
- Over Temperature
Protection
- Automatic Current
Reduction, 0.5 Sec after Last Step Input
- 14 Selectable
Resolutions Both in Decimal and Binary
- Micro-step Resolutions:
1/2, 1/4, 1/5, 1/8, 1/10, 1/16, 1/25, 1/32, 1/50,1/64, 1/125, 1/128,
1/250 and 1/256
- Extremely Small Size,
2.75"(69.9 mm) X 3.00" (76.2 mm) X 1.20" (30.5 mm)
|
|
The STPMDRV-404 is a high performance, low cost
micro-stepping driver that incorporates advanced surface mount and ASIC
technology. The STPMDRV-404 is small, easy to interface and use, yet
powerful enough to handle the most demanding applications.
The STPMDRV-404 has 14 different resolutions (both in binary and
decimal) built into the driver. The development
of proprietary circuits has minimized ripple current while maintaining a
25 KHz chopping rate. This
prevents additional motor heating that is common with drivers requiring
higher chopping rates
The low inductance stepper motors can be used to
improve high speed performance and system efficiency.
|
| ELECTRICAL
SPECIFICATIONS |
|
Supply Voltage
|
+12 to +40 VDC
|
|
Phase Current
|
0.1 to 4.0 Amps
|
|
Auto Current Reduction
|
Resistor Programmable, 0.5 Seconds
After Last Step Pulse
|
|
Step Frequency
|
0 to
5 MHz |
| MECHANICAL
SPECIFICATIONS |
| Dimensions |
2.75" (69.9 mm) X 3.00" (76.2 mm) X 1.20" (30.5 mm) |
| Mounting Pattern |
Four 6-32 Screws, 0.15" Diameter
(3.8 mm) |
|
ENVIRONMENT
|
|
Heat Sink Temperature |
0 oC to 70 oC |
|
Ambient Temperature
|
0 oC to 50 oC
|
|
Storage Temperature
|
-40 oC to 125 oC
|
|
Humidity
|
0 - 95% with no condensation
|
Ordering Information
Motion Control Components
|
